1307-R15040039-AA
Page 4 of 10
1-800-59-ROUSH
USE EXTREME CAUTION WHEN WORKING UNDERNEATH VEHICLE.
Never get near or
underneath vehicle until you are confident that it is safely supported and will not move or fall
from its raised position.
DO NOT USE A BUMPER JACK!
NOTE!
There is a limited amount of working space underneath the car around the transmission
and floor pan area while replacing and installing the shifter assembly, however, shifter removal
and replacement can be performed without removal of drive shaft. If drive shaft is removed to
facilitate the installation, consult the manufacturer’s service manual for correct procedure.
Disassembly (
ROUSH Billet Shifter Handle Removal)
1.
Use a 17mm wrench to loosen the jam nut below the shifter knob. Turn the jam nut
clockwise to unlock it from the knob.
2.
Remove the shifter knob from the handle by turning the knob counter-clockwise. Then
remove the jam nut from the handle by turning it counter-clockwise.
3.
Remove the shifter boot, by lifting up on the boot surround (the shifter boot just snaps in
place on the console).
