ROUND Pools AMBASSADOR, Руководство по установке

Страница: 30 / 40

8
No Diving or Jumping. Observe all Safety Rules.
3-8
4. Fasten the liner place
(BEADLOCK/SNAPBEAD LINER ONLY)
a. With a snap bead liner you will not
use the plastic coping strips that are
packed in the parts carton of many
pools. You can discard those pieces
(if they are included). Instead, you
should have received a beaded liner
track (referred to as a “coping bead
receiver” in this image).
b. The beaded liner track should be
installed onto the pool wall all of the
way around the pool. These pieces
should be as close together as pos-
sible. Leaving spaces between bead
tracks can cause liner problems later
on.
c. Once all of the beaded liner track is
on the wall, you can snap the liner
bead into the beaded liner track at
four random points around the pool.
After that is done, and you are satis-
fied with how the liner is situated
within the pool, you can continue
snapping the remainder of the liner
into place around the pool.
d. Go around the entire pool again
making certain that the liner is se-
curely snapped into the track. This is
important to confirm so that the liner
does not pull out while under the
pressure of being filled with water.
NOTE: Some liners may fit very tightly,
it is better to install uprights, top
plate and ledge before going onto
next step. See Section 4.
22