Roughneck 42595, Руководство пользователя

Страница: 8 / 14

7
Set the guides to the chain width using the set screw (A) so
that it is firmly fixed in the clamping screw by clamping the
lever control (B).
Set the feed by adjusting set screw (E).
On severely worn chains, the lateral position of the chain
guide should be secured with a set screw (D).
Set the top plate angle by adjusting the set screw (pg. 3, pg5)
corresponding to the readout scale (F).
The Vise Angle should be set up by adjusting the set
screw(G).
8.Grinding
With the clamping screw adjusted, the vise angle
set up (Note: RH and LH teeth to be differentiated)
and the top plate angle preset, lower the grinding disc to the tooth. The grinding depth may be
set by adjusting the set screw (K).
Some types of chains require that the clamping screw be tilted by 5°-10°
（
ref. Tilt Angle in
Table on page 9
）
.
Now, the machine may be switched on and the chain grinding may be started by gently
pressing the disc on the chain, Adjust the pressure as necessary. Mark the start of grinding
with a piece of chalk and grind all the teeth in one direction, then turn the clamping screw
(mind the angle) and grind the teeth in the opposite direction.
With worm chains, the lateral guide position (Fig.10, Position M) should be set so the grinding
disc doesn’t touch the guide.
Avoid any strong thrusts as the teeth might collide and could cause damage to the chain.
SHARPCHAIN.COM