Roughneck 42595, Руководство пользователя

Страница: 5 / 14

4
nonskid shoes are recommended, especially if working in damp areas. Keep long hair
out of the way with a cap or hairnet. Wear protective goggles or safety glasses
approved for the job.
•
Do not use the power cord for carrying or hanging the machine. Do not use the cord to
pull out the plug from the outlet. Protect the cord from excessive temperatures, oil,
corrosive solutions and sharp edges.
•
When working outdoors, use extension cords designated for outdoor use.
•
Check the machine cord regularly; if it is damaged, have it replaced by a skilled
electrician. Check the extension cords as well and replace them if damaged.
•
Avoid any abnormal posture. Mind safe footing and keep your balance at all times.
•
Keep the handle dry and free of dirt, oil and grease.
•
Unplug the machine when not in use or before performing maintenance of disc
replacement.
•
Before turning on the machine, check to see that any wrenches and adjustment tools
have been removed.
•
Avoid turning the machine on unintentionally.
•
Be attentive. Mind what you are doing. Start a job only when you feel good. Never use
this machine when distracted.
•
Before using the machine, check protective devices and parts for any damage that
may not allow them to function as intended. Check to see that moving parts move
freely, do not drag and are not damaged. All parts should be installed properly to
ensure the machine’s safe operation. Damaged protective devices and parts should
be repaired by a qualified professional, or replaced. Damaged switches should be
replaced by an authorized service center. Do not use a machine with a defective
ON/OFF switch.
•
NOTE: This machine is in compliance with any respective safety provisions.
Professionally qualified technicians must do any repairs and only genuine spare parts
should be used. If these provisions are not observed, the user is in risk of injury.
4. Assembly
The saw-chain grinding machine is delivered partly assembled. One part consists of the base
on which the chain guide is located. The other part is a bearing arm with the motor and
handgrip.
Assembly must be performed with the machine unplugged!
The machine design provides for either a bench-or wall-mount installation.
When installing it on a bench, put the machine on the
edge of the bench to the stop (Fig. 1) and screw it to the
desk using the holes in the base.
SHARPCHAIN.COM