Rottler Manualmatic SG8MTS, Руководство по эксплуатации и обслуживанию

Страница: 14 / 109

Section 2 Installation SG8MTS Manual
www.rottlermfg.com
2-3
______Have the operator read through the operation manual before training begins. This will help him
be familiar with the button pushing sequences. Have the operator read through the manual again
after training and some of the sequences will make more sense.
______Calibrate angle sensor
MACHINE START-UP
When starting the machine for the first time, it may move out of control. Make
sure all hands are clear of machine parts. Be ready to press the Emergency
Stop button if needed.
______Turn main power on from the main incoming breaker box.
MACHINE MOVEMENTS
______Make sure there is nothing obstructing the full vertical travel of the machine.
______When the machine is on the clamp mode and the air pressure is with the requirements, try to
move workhead to verify that you have a solid clamp of Work head.
______Place the level on the leveling post. The level assembly is referenced to the spindle via the level
pin. It is therefore important to check alignment of the pin in reference to the spindle. Even though
the level has been carefully calibrated at the factory, it is a good idea to recheck calibration before
putting the machine into service. In the event that the level is dropped or handled roughly then the
following recalibration methods should be implemented. If calibration is required refer to manual
for Calibrating the Digital Level
______Start the spindle and verify operation.
INSTRUCTING THE OPERATOR:
Note: Rotter employees and representatives per company policy are not permitted to provide end
user of Rottler equipment with any OEM specifications for the workpiece that is created by end
user using Rottler equipment.
______Using the operating manual as a guide explain the function of all buttons.
______Cycle all machine movements and supervise the handling of same by operator.
______Demonstrate the engaging of the fine feed system.
______Point out safety features to customer and operator.
Do not push any buttons without thinking of safety first.
Do not assume the Digital level has been calibrated rotate 180 to verify
alignment.
______The following is a checklist to go through every time the machine is started to begin machining a
seat.
• Work piece secure
• RPM set
• Tool holder adjusted to the correct setting base on the type of seat you will be machining
• Tool holder locked in place
• Floating of the Workhead and clamping
______Proceed to have operator to machine a seat under you control.
______ Parts ordering, refer to the operating manual for part numbers and description.
______Review Emergency stop procedure and with operator per operating manual.