E-M-HG2-S-V1_04
Rotronic AG
Bassersdorf, Switzerland
Document code
Unit
HygroGen2 humidity and temperature
generator: Instruction Manual
Instruction Manual
Document Type
Page
2
of 46
Document title
© 2009-2010; Rotronic AG
2
E-M-HG2-S-V1_04
HygroGen 2 - Quick Start Guide:
Congratulations on selecting the HygroGen humidity and temperature generator; the unit will enable
you to perform accurate and rapid humidity and temperature calibrations for many years. Before
starting to use the instrument there are a few key points you should pay close attention to:
1. Unpacking
Carefully remove the HygroGen from the packaging and visually inspect for any signs of damage and
check the supply contents defined on page 4. Report any damage or missing parts immediately to your
supplier.
2. Pre-checks
First check that the water reservoir is empty by inserting the HG-Fill syringe and trying to extract water.
If you find that the unit was shipped with water, immediately report this to your supplier and do not
power the unit.
3. Installation and Safety
Before using the instrument, please read Sections 1.1 and 4.1 and take particular note of the content.
4. Power shutdown
Incorrect shutdown procedures can lead to failure of the HygroGen. Please read Section 4.9 and take
note of the content.
5. Getting started
After taking note of the guidance above:
•
Fill the water reservoir with distilled water as described in Section 2.1
•
Check power connection
•
Switch on the instrument
•
Allow to stabilise to set-points
