rotork Pakscan IIS, Техническое руководство

Страница: 17 / 84

Pakscan IIS Technical Manual Issue 1.0
Publication S130E 17
5. INITIAL SETTING UP
Before applying any power to the master station you may wish to check that the internal settings of the
jumpers match your system requirements. These jumpers will have been factory set to the default positions, or
to user specified positions, prior to dispatch.
In addition to the internal jumpers there may be a need for you to fit external links to achieve satisfactory
operation of your installed unit. These links can be fitted prior to installation.
The main pcb cover carries a label giving details of all the connection jumper settings and also showing how
to install the field cabling. There are no jumper settings or links to be made on the display pcb on the door.
5.1 Jumper and Link Settings
The main circuit board contains a number of Jumpers and Links to set some parameters for the performance of
the unit. These are factory set and the unit will be fully operational. However there are links which you may
need to fit to match your particular application. There are no jumper links on the display board that require
customer adjustment.
The diagram Fig. 6 is a view of the main circuit board with the door open and on the left.
The function of the jumpers and links is listed in the table below, please note that some select the type of
integrated circuit used, and therefore may vary from one unit to another.
(no = not fitted, yes = fitted)
Jumper / Link . Function Default Action
J1 Dual Port Memory size select no not applicable
J2 EPROM select B position set EPROM size
J3 EPROM select A position set EPROM size
J4 RAM select B position set RAM size
J5 Port 1 mode A position select RS232
J6 Port 1 RTS A position select RTS
J7 Port 2 CTS A position select CTS
J8 Port 2 mode A position select RS232
J9 Port 2 RTS A position select RTS
J10 Port 1 CTS A position select CTS
J11 Memory Capacitor discharge no not discharged
J12 Watchdog reset disable no enable reset
J13 Plant power monitor no check main power supply
J14 Plant power external supply yes use main power supply
J15 Flash memory A position enable support
LK1 P+Q jumpers (physical address) no not applicable
LK2 Not fitted