rotork Pakscan IIE, Системное руководство

Страница: 36 / 132

Pakscan IIE System Manual
36 of 132 Publication S177E V2.0 Issue 03/05
Top Menu – Master Station Status
1.
Master Station Status, Alarms and Tag
1. Reset Loop (reconfigure the 2-wire loop)
2. Start Configuration Mode (enable the use of MasterTools)
3. Change Master (Hot Standby Systems only)
4. Diagnostics (enter Diagnostic mode) Software Version, Port status
1. Port 1 Port Activity
2. Port 2 Port Activity
3. Loop Loop status
1. Loop Map
2. Loop Test
3. Address fault prompt
4. Inter Unit comms
5. Setup (enter Setup mode)
1. Ports
1 or 2 Select Port 1 or 2
1. Set use (Port 2 only)
2. Set protocol
3. Set speed
4. Set Parity
5. Set Port mode when Standby
Passive or Active
6. Set Alarm Options
Separate or Linked alarms for ports
2. Standby Setup Actions
1. Copy data to standby
2. Copy address to standby
3. Copy Master Station Tag to standby
3. Loop Shows current loop status and settings
1. Set speed (shows current speed)
2. Set new FCU speed (for global change)
3. Set Number of FCU
4. Set Doubling status
5. More options
1. Retain last data on comms fail
2. IQ DV convert (0% to ‘Close’)
4. Address Shows current address settings
Set master station address
5. Tags Sets up all tags
1. Set master station tag
2. Select FCU number (to change tag)
3. Set FCU tag
6. Time Shows current date and time setting
1. Set Date
2. Set Time
7. ESD Shows current ESD option settings
1. Enable/Disable Serial Comms ESD
2. Enable/Disable Keypad ESD
3. Enable/Disable hard wired ESD input
8. Security Shows current security level
1. Set PIN in or out of use
2. Set PIN
3. Set access level
9. ESD (initiate an ESD)