Roto-Mix 920-18, Руководство по сборке, эксплуатации и запасным частям

Страница: 23 / 97

LUBRICATION
DISENGAGE PTO & SHUT OFF POWER BEFORE LUBRICATING THE MACHINE.
LOOSE OR FLOPPY CLOTHING SHOULD NOT BE WORN BY THE OPERATOR.
OIL BATH:
Fill the oil bath with 30 weight motor oil to sight plug level.
GREASE BANK:
Grease every 10 hours.
FRONT END BEARINGS:
Grease every 10 hours.
INPUT BEARINGS:
One (1) on input shaft beneath mixer/feeder. Grease every 10 hours.
PTO SHAFTS & U-JOINTS:
Grease every 10 to 20 hours.
HYDRAULIC PUMP DRIVE:
Grease every 10 to 20 hours.
2:1 GEARBOX:
Prior to operation, remove the uppermost plug and replace with vent plug
provided. After the first 100 hours of operation, drain the initial oil, preferably warm.
Flush the gear case with an approved non-flammable, non-toxic solvent and refill with
oil. Thereafter oil should be changed every 2000 hours or every 12 months, whichever
occurs first. Fill the gearbox with approximately 2-1/2 pints (1.2 liters) of (
Mobil Delvac
Synthetic Gear Oil 75W-90 ).
MIXER DOOR CYLINDER HYDRAULICS (TRUCK): Replace hydraulic filter after first 100
hours of operation then every 500 hours of operation with 10 micron element. Replace
fluid every 2000 hours of operation or every year, which ever occurs first, with
approximately 1 gallon (3.7 liters) of
(CITGO TRANSGARD TRACTOR HYDRAULIC
FLUID - Material Code 633310001).
FILL OIL HERE ON
TRUCK DRIVELINE
CHECK OIL LEVEL HERE
ON TRUCK DRIVELINE
CHECK OIL LEVEL HERE
ON STATIONARY DRIVES
FILL OIL HERE ON
STATIONARY DRIVES
ADJUST TRAILER HITCH CLEVIS
Mixer should be approximately level when attached to tractor.
Adjust clevis by changing hole location on tongue.
Hitch Pin Size — 1” x 7”
23