Rothenberger ROWELD HE, Инструкция по эксплуатации

Страница: 14 / 24

12 ENGLISH
2 Technical data
Power supply ............................ 230V AC, 50/60 Hz, 1300 W
Working range ..........................

16-125mm
Protection / Protection class ..... I / IP20
Dimensions .............................. 500x200x65mm
Weight ...................................... 3,1 kg
3 Function of the unit
3.1 Overview (fig. A)
1 Isolated Handle 6 temperature indicator
2 Flex with Plug 7 Heating plate
3 Pushbutton 8 Heating jack
4
“+“ / “-“ button
9
Heating arbours
5
red diode “Stand by“
10 Counter pin
The handy pipe socket welding machines are designed fort he overlap welding of PE, PP and
PVDF plastic pipes and shaped pieces in a workshop and on sites.
There are two methods of welding: type A und type B .
Using method A the pipe is used without peeling, it is simply chamfered.
Using method B the pipe must be peeled to a certain length and then chamfered.
The ROTHENBERGER heating jacks (8) and -arbours (9) are designed in form A and are
marked accordingly on the uncoated rear.
3.2 Operating instructions
The Heating Element must be used by well trained and autorized operators only!
3.2.1 Putting into operation
Please read the operating- and safety-instructions attentively before putting the
heating element into operation!
Do not use the heating element in explosive environments or bring it into
contact with easily flammable materials!

Fit the corresponding heating jacks (8) and heating arbours (9) . Secure heating arbour (9)
with counter pin (10) and thighten the screw M6x40 with allen key ( s.fig. A ).

Insert the heating element with the mounting groove in a table clamp (no.: 55540) or floor
stand (no.: 55539).

Connect power plug to the power supply stated on the type plate.
The red diode “Stand by“ lights up. That is: there is a voltage being applied. Switch on the
heater element using the large pushbutton (lights up green) and select the desired
temperature (160°C to 285°C) using the “+“ or “-“ button.
Heating up of the heater element is displayed by a yellow diode on the heater element. A hori-
zontal bar also appears on the temperature indicator. The yellow diode goes out shortly before
reaching the set temperature (tol/-3°C) and the green one lights up. After a further 10
minutes the heating element is ready to use. Check the temperature using a temperature
measuring instrument.