Rotex GSU 320, Руководство по эксплуатации

Страница: 6 / 48

1 x Safety
6 BA ROTEX GSU - 09/2007
Hydraulic system connection
• When operating the ROTEX GasSolarUnit, especially when using the solar energy, the storage tank temperature can exceed
60 °C. Protection from scalding (hot water mixing device e.g. VTA32 15 60 16 ) should therefore be included when
installing the system.
Device installation room
• Operate ROTEX GasSolarUnit only if sufficient combustion air supply is ensured. If you operate the ROTEX GSU in ambient-
air-independent mode with an air/ flue gas system (LAS) dimensioned according to ROTEX standard, this is guaranteed
automatically and there are no further conditions to be met in the device installation room.
• Make sure that there is an opening to the open air for air inlet, of at least 150 cm
2
if you operate in the ambient air dependent
mode.
• Do not operate the burner in the ambient air dependent mode in rooms with aggressive vapours (e.g. hair spray, perchloroeth-
ylene, carbon tetrachloride), heavy dust formation (e.g. workshops) or high humidity (e.g. laundries).
• Always maintain the minimum distances from walls and other objects (see Chapter 7.1).
Operation
• Operate ROTEX GasSolarUnit only with the storage tank filled to overflow.
• Operate ROTEX GasSolarUnit only with closed silencer hoods.
Instruction by the installer
• The handover includes instruction in the operation and control of the ROTEX GasSolarUnit by the installer, using the operating
instructions.
• Document the handover by filling in and signing the attached installation and instructions form together with the installer.
Disposal
• Through the environmentally-friendly design of the ROTEX GasSolarUnit, ROTEX has complied with the standards for
environmentally-friendly disposal.
• Proper disposal in compliance with the respective national stipulations of the country of use is the responsibility of the owner.
Documentation
• The technical documentation contained in the scope of supply is part of the device. It must be stored in such a way as to
ensure that the operator or technical personnel can always refer to it.