Rotary SPOA7 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 4 / 12

4
CAUTION
DO NOT go under vehicle if locking latches
are not engaged.
5. While Using Lift:
A. Avoid excessive rocking of vehicle while on lift.
B. Always use safety stands as needed or when
removing or installing heavy components.
6. To Lower Lift:
A. Remove all tools or other objects from lift area.
B. Raise lift off locking latches.
C. Pull LATCH release handle fully and hold.
D. Push LOWERING valve handle to lower, Fig. 4.
Note: Both LATCH release and LOWERING valve handles
are deadman-type design. Each must be held down to
lower lift. Do not override self-closing lift controls.
7. Remain clear of lift when lowering vehicle. Observe
pinch point warning decals.
8. Remove adapters from under vehicle. Be sure lift is fully
lowered before removing vehicle.
9. If lift is not operating properly, Do Not use until
adjustment or repairs are made by qualified lift service
personnel.
SPOA7 M-PAD OPERATING INSTRUCTIONS
To avoid personal injury and/or property damage, permit only trained personnel to operate lift.
After reviewing these instructions, get familiar with lift controls by running the lift through a
few cycles before loading vehicle on lift.
Always lift the vehicle using all four adapters. NEVER raise just one end, one corner, or one side
of vehicle.
Authorized personnel
only in lift area.
©
CAUTION
Read operating
and safety manuals
before using lift.
©
SAFETY
INSTRUCTIONS
CAUTION
Lift to be used
by trained operator
only.
©
? ?
?
CAUTION
Use height extenders
when necessary
to ensure
good contact. ©
CAUTION
Use vehicle
manufacturer’s
lift points.
©
CAUTION
Auxiliary adapters
may reduce
load capacity.
©
WARNING
Remain clear of lift
when raising or
lowering vehicle.
©
CAUTION
Always use
safety stands when
removing or installing
heavy components. ©
WARNING
Do not override
self-closing
lift controls.
©
WARNING
Remain clear of lift
when raising or
lowering vehicle.
©
Observe and heed SAFETY, CAUTION and WARNING labels
on the lift.
1. Lift must be fully lowered and
service bay clear of all personnel
before the vehicle is brought on
lift. Swing arms out to full drive-thru
position.
2. Spot vehicle over lift with left front
wheel in proper spotting dish position,
Fig. 5. Be sure vehicle wheels and/or
mud flaps clear pad end ramps.
3. Loading: DO NOT raise limousines
or pickup trucks. DO NOT raise SUV's,
vans, or other specialty vehicles not of
a unibody construction.
Before lifting vehicle be sure that:
A. Pads are in secure contact with
frame or support structure at outer
body.
B. Certain vehicles such as Camaro,
Firebird, Escort, or Chrysler "K" Cars or
others may require additional clearance under carriage
or exhaust system from contacting pad support. Use
3" high auxiliary rubber pads. Locate under frame
or support structure at outer body using vehicle
manufacturer's recommended pick up points.
Note: Allow 2 seconds between motor starts. Failure to
comply may cause motor burnout.
4. To Raise Lift:
A. Push RAISE switch on power unit, Fig. 4.
B. Stop before making contact with vehicle. Be sure
wheels and/or mud flaps clear pad end ramps.
C. Raise vehicle until tires clear the floor.
D. Stop and check pads for secure contact at vehicle
manufacturer’s recommended lift points.
E. Continue to raise to desired height only if vehicle is
secure on lift.
F. Repeat complete spotting, loading and raising
procedures if required.
H. Lower lift onto locking latches.
IMPORTANT
WARNING
WARNING
Clear area if vehicle
is in danger of falling.
©