background image

6

CAUTION

Lift to be used 

by trained operator

only.

©

? ?

?

CAUTION

Always use 

safety stands when 

removing or installing 

heavy components. ©

The messages and pictographs shown are generic in nature and are meant
to generally represent hazards common to all automotive lifts regardless of
specific style.

Funding for the development and validation of these labels was provided by
the Automotive Lift Institute, PO Box 33116 Indialantic, FL. 32903-3116.

They are protected by copyright.  Set of labels may be obtained from ALI or
its member companies.

ALI/WL101c

Ó

 1992 by ALI, Inc.

Authorized personnel 

only in lift area.

©

CAUTION

CAUTION

Use vehicle

manufacturer’s

lift points.

©

CAUTION

Use height extenders

when necessary 

to ensure 

good contact.

©

CAUTION

Auxiliary adapters

may reduce 

load capacity.

©

If you are not completely familiar with automotive lift maintenance 

procedures;  STOP:  Contact factory for instructions.  To avoid 

personal injury, permit only qualified personnel to perform 

maintenance on this equipment.

•  Always keep bolts tight.  Check periodically.

•  Always keep lift components clean.

•  Always if oil leakage is observed, call local service 

representative.

•  Always if electrical problems develop, call local service 

representative.

•  Daily:  Check cables and sheaves for wear.  Observe for frayed 

cable strands.  Wipe cables with a rag to detect hard to see 

small broken cable strands.  Replace cables showing any 

broken strands.  Replace worn parts as required with genuine 

Rotary parts.

•  Daily:  Inspect rubber pads for damage or excessive wear.  

Replace as required with genuine Rotary parts.

•  Daily:  Inspect adapters for damage or excessive wear.  

Replace as required with genuine Rotary parts.

•  Monthly:  Check equalizer cable tension.  Adjust per lift 

installation instructions.  If there are no more threads available 

for adjustment, replace the cable.  Do not use washers to 

stand off the nut to use previously used threads.

•  Monthly:  Lubricate locking latch shafts.  Push latch handle 

several times for oil to penetrate pivot points.

•  Every 3 Months:  Check anchor bolts for tightness.  Anchors 

should be torqued to 65 ft/lbs.

•  Semi-Annually:  Check fluid level of lift power unit and refill if 

required per lift installation instructions.

•  If Lift stops short of full rise or chatters, check fluid level and 

bleed both cylinders per lift installation instructions.

INSPECTION and MAINTENANCE

     See ANSI/ALI ALOIM booklet for periodic 

inspection checklist and maintenance 

log sheet.

SAFETY

INSTRUCTIONS

Do not operate 

a damaged lift.

©

Read operating

and safety manuals

before using lift.

©

SAFETY

INSTRUCTIONS

The messages and pictographs

shown are generic in nature and

are meant to generally represent

hazards common to all automotive

lifts regardless of specific style.

Funding for the development and

validation of these labels was

provided by the Automotive Lift

Institute, PO Box 33116 Indialantic,

FL. 32903-3116.

They are protected by copyright.

Set of labels may be obtained from

ALI or its member companies.

  C  1992 by ALI, Inc.                   ALI/WL101s

SAFETY

INSTRUCTIONS

Proper maintenance

and inspection

is necessary

for safe operation.

c

WARNING

Clear area if vehicle 

is in danger of falling.

©

The messages and pictographs shown are generic in nature and are meant
to generally represent hazards common to all automotive lifts regardless of
specific style.

Funding for the development and validation of these labels was provided by
the Automotive Lift Institute, PO Box 33116 Indialantic, FL. 32903-3116.

They are protected by copyright.  Set of labels may be obtained from ALI or
its member companies.

ALI/WL101w

Ó

 1992 by ALI, Inc.

WARNING

Position vehicle 

with center of gravity 

midway between 

adapters.

©

WARNING

Remain clear of lift

when raising or

lowering vehicle.

©

Keep feet 

clear of lift 

while lowering.

©

WARNING

WARNING

Do not override

self-closing

lift controls.

©

WARNING

Avoid excessive

rocking of vehicle

while on lift.

c

MAINTENANCE INSTRUCTIONS

•  Replace all caution, warning or safety 

related decals on the lift if unable to read 

or missing.  Reorder labels from Rotary 

Lift.

Содержание SPOA7 Series













Отзывы: