Rotary SGL35, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 53

5. Operation
12
117592 ● 03/2013
The vehicle must now be lowered by an
authorised competent person.
ONLY use adapter extensions from the lift
manufacturer. DO NOT use wood or concrete
blocks or other improvised extensions.
Check the condition of the pick-up points on the
vehicle. These should be free of grease, oil and
dirt. Arms swing under the vehicle and position the
adapter on the pick-up points recommended by the
vehicle manufacturer (Fig. 4). Bring the adapter to
the corresponding height to stop the car straight
and properly balanced.
When raising and lowering, monitor the lifted
vehicle constantly
. If the lift is not synchronised,
pause the movement and determine the cause.
Monitor the tension of the synchronisation cables
through the inspection window in the plate frame,
and if there are irregularities, shut down the lift
and contact the service department.
Raising
1. Press the Up

button. Raise the vehicle
slightly.
2. Check that the vehicle pick-up points are
secure.
3. Press the Up

button. Raise the vehicle to the
desired height.
4. Make sure that each pinion engages the ring
gear as soon as the slider block loses contact
with the floor.
5. If one of the pinions does not engage the ring
gear, the bolt with the pull ring at the top can be
seen to protrude further than normal at the top
on the guide shaft of the pinion (Fig. 8, in
normal position). In this case, lower the slider
block and re-position the problematic arm.
6. Release the SAFETY lever and the Up button

as soon as the working height has been
reached.
7. When the required height has been reached,
the lift can engage the safety latch.
8. Set the main switch to ”0", as soon as the
necessary working height has been reached.
Down
1. Connect the control unit to the power supply
and set the main switch to “1“, pull the SAFETY
lever and push the DOWN button  to lower the
lift to the required level.
2. If you cannot pull the lever down, the latching
mechanism has engaged. Press the UP  and
DOWN  buttons at the same time so that the
slider block rises and the lever is released. Then
lower the vehicle.
The latch mechanism, the lever, and the "Up"
and "Down" switches are dead man’s
switches. The lift is raised and lowered as
long as the buttons and the lever are
engaged.
3. Set the main switch to “0“.
5.6 Using the lift

Prevent extreme vibrations from the vehicle
whilst it is positioned on the lift

If required, always use safety stands as
stabilisers when removing or fitting heavy
components (i.e. engines, gearboxes etc). Use
4 safety stands

When lowering, stay outside the range of the lift.
Do not stand in the lowering zone.

Wear protective goggles when working
underneath the vehicle

If necessary, also use support straps to stabilise
the vehicle on the arm when disassembling
parts.
5.7 Before lowering the lift

Remove all tools and other objects from the lift
zone.

Ensure that no-one is in the lift zone.

Ensure that there are no people or objects in the
drive-off zone before driving the vehicle from the
lift.
5.8 Driving the vehicle from the
lift
1. Secure the vehicle against rolling.
2. Ensure that the arms are in their outermost
position on full drive-thru position before driving
the vehicle from the lift.
i
i
i
i
i
i