G
Connect the main power wires to the subwoofer either from the sides or from the
rear. Tighten the wire screws down with a phillips or flat head screwdriver.
H
Without the grill on the sub use a #2 phillips screw driver secure the subwoofer
to the mounting location using (4) phillips-head screws. Use the top, bottom, left
and right holes as shown in the image below.
H
Place the grill on the basket and use a #2 phillips screw driver secure the
subwoofer to the mounting location using (4) phillips-head screws through the 4
remaining open holes.
E
Place the sub into the mounting cutout to ensure it will fit. Remove additional
material if needed. Once the sub fits properly, align the sub to the desired
orientation and use a center punch or pencil to mark the mounting holes for the
screws to secure the sub. Remove sub from the cutout and drill the holes with
either a 5/32“ drill bit (soft materials like wood or MDF) or a 11/64” bit (harder
materials like fiberglass).
Installa
tion
RMA 10” / 12” Speaker Installation Instructions
www.roswellmarine.com
8
www.roswellmarine.com
NOTE:
If drilling through fiberglass/gelcoat, be sure to run the drill in reverse until you
are through the gelcoat, switch the drill into forward and finish drilling as normal. Then
come back with a countersink bit and remove the gelcoat surrounding the hole. This
will help avoid cracking/damaging the gelcoat around the mounting location.
1)
2)
RMA 10” / 12” Speaker Installation Instructions
www.roswellmarine.com
U
se
& W
arran
ty
9
www.roswellmarine.com
Black (-)
Red (+)
x4
x4
5/32”
Enjoy your new Roswell sub!
#2
#2
#2
