Nautique Deluxe Mirror Assembly and Installation Instructions
www.roswellmarine.com
THREADLOCKER
F
G
1
2
3
D
E
3
Thread one of the bolts provided with your mirror arm
into the center hole through the two clamps sections,
just enough to hold them in place. Do not fully tighten
yet.
Apply RED Loctite to the other two bolts provided and
thread the bolts in the remaining two holes. Remove
the center bolt from step D, apply Loctite, and re-fas-
ten. Do not fully tighten these three bolts yet.
To properly tighten the clamp sections together it is important to follow a tightening sequence. Start by tightening the center bolt
two turns, then tighten each of the side bolts two turns. Repeat until the two clamp halves are touching and no gap is apparent.
Make sure all bolts the are tight.
Assemble the mirror to the mirror clamp.
Make sure the rubber disc is assembled
between the mirror housing and the
mirror clamp.
(Make sure to align the
square fitting on the back of the mirror
with the one on the clamp.)
Tighten the
mirror in place by threading the hand
knob on to the mirror bolt.
By loosening the hand knob, you are able
to adjust the mirror in all directions. Simply
re-tighten the handle once the mirror is at
your preferred angle.
If any excessive resistance is felt during tightening, do
not force the bolt(s). This could strip the threads on
your part. Try loosening the bolt(s) and repeating the
tightening sequence.
Tighten
3rd
Two turns at a time
Tighten
1st
Two turns at a time
Tighten
2nd
Two turns at a time
Mirror
Rubber Disc
Mirror Clamp
Hand Knob
x1
x2
Torque: 15 ft-lbs