Rostra 250-8052, Руководство по установке

Страница: 10 / 12

PAGE 10
TESTING AND REASSEMBLY
TESTING
1. RECONNECT NEGATIVE BATTERY CABLE AND TORQUE TO 3 FT*LBS . RE-ENTER
ANY THEFT DETERRENT INFORMATION, IF APPLICABLE.
2. TURN THE IGNITION SWITCH ON . PRESS THE MENU BUTTON TO SWITCH FROM
VIDEO 1 TO VIDEO2. VERIFY THAT THE REARSIGHT MONITOR IS ON AND THE
CAMERA’S PICTURE APPEARS. PRESS THE POWER BUTTON. PUT THE VEHICLE
IN REVERSE. VERIFY THAT THE CAMERA’S PICTURE APPEARS.
3. IF THERE IS NO PICTURE, VERIFY ALL CONNECTIONS ARE SECURE.
REASSEMBLY
1. REINSTALL ALL TRIM PIECES TAKING SPECIAL CARE TO ENSURE HARNESSES
AND WIRING CONNECTIONS ARE PROPERLY SECURED.
2. BE SURE HARNESS IS NOT PINCHED OR BOUND BY TRIM PIECES.
3. PLACE THE OWNER’S CARD IN THE GLOVE BOX.
4. RECONNECT ALL DISCONNECTED BULBS AND CHECK FOR FUNCTION.
INSTALLATION TIPS
ƒ
CONFIRM PROPER CABLE EXTENTION CONNECTOR ORIENTATION AND
ALWAYS VERIFY PROPER ENDS ARE ROUTED IN PROPER DIRECTION.
ƒ
IT IS A GOOD IDEA TO DRY FIT THE KIT BEFORE PERMANENTLY ATTACHING
THE UNIT TO INSURE PROPER ORIENTATION AND OPERATION BEFORE
BEGINNING INSTALLATION FOR FAMILIARIZATION OF COMPONENTS.
ƒ
READ ALL INSTRUCTIONS AND WARNINGS BEFORE BEGINNING THE
INSTALLATION OF THIS KIT.
ƒ ALWAYS TREAT ANY METAL EXPOSED DURING INSTALLATION WITH RUST
PREVENTATIVE COMPOUND TO PREVENT RUST AND OR CORROSION
FAILURE.
ƒ ALWAYS SEAL ANY HOLES DRILLED WITH PROVIDED SEALING PUTTY TO
PREVENT WATER INFILTRATION INTO UNPROTECTED OR AREAS OF
CONCERN.
ƒ
CONFIRM INTEGRITY OF MECHANICAL AND ELECTRICAL CONNECTIONS
BEFORE MOVING TO NEXT INSTALLATION SEQUENCE.