Station 6 Preamplifier and Monitor Controller
9
When Station 6 is used with external A/D and D/A converters, it must operate in analog mode. There is no need to install
a digital module. With no digital module installed, the unit automatically enters analog mode.
If a digital module is installed, just set the DIP switch 6 to position ON. This will activate analog mode and deactivate the
digital module.
Inputs Mic1 and Mic2 are sent to the external A/D converter and to the DAW. Each of the inputs Mic1 and Mic2 have an
Insert Point for use with analog equipment like Equalizers, compressors, filters, what not. Note that the analog equipment
is placed in the signal chain before the external A/D and the DAW.
The monitor (master) outputs from the DAW and the external D/A are connected to the AUX Line 3 and AUX line 4 inputs
and directly routed to the Monitor Left and Right outputs.
The Cue outputs from the DAW and the external D/A are connected to the AUX Cue Left and Right inputs and routed, via
the mixer, to the Cue(headphones) Left and Right outputs.
The Cue(headphone) outputs receive the signals from a local mixer, which has 3 input sources.
1. The main Cue output from the DAW and the external D/A, via the AUX Cue Left and Right inputs
2. The direct feeds from the microphone channels via potentiometers at the front, sourced from the Insert Point Returns.
3. Talk Back Input from the TB microphone input, controlled by the TB switch and volume potentiometer at the front.
