Reader Operation
30
AYC-Qx4 Family Installation and Programming Manual
3.
Enter one of the following codes:
0
– Always off
1
– Always on
2
– Backlight is off, activates for 10 seconds when a key is
pressed (left LED also goes on), after which it dims until off
(left LED also goes off)
3
– Backlight is dimmed, activates for 10 seconds when a key
is pressed (left LED also goes on), after which it returns to a
dimmed level
You hear three beeps.
The system returns to Standby mode.
4.2.8
Return to Factory Default Settings
You must be very careful before using this command! This
erases the entire memory and return all codes to their factory
default setting.
To return to factory default settings:
1.
Enter Programming mode.
2.
Press
0
to enter Menu 0.
Both LEDs flash red.
3.
Enter your 4-digit Programming code.
If the Programming code is valid, all memory is erased. You hear
three beeps and the reader returns to Standby mode.
If the Programming code is invalid, you hear a long beep and the
reader returns to Standby mode without erasing the memory of
the reader
Red
Red
Green
Red
