Mounting Instructions
AY-R12 Installation Manual
9
3.
Mounting Instructions
Installation of an RFID reader adjacent to metallic surfaces
might alter the reader’s specifications. To diminish this
interference, use a plastic spacer when mounting the reader.
When mounting the reader, you must remove the snap-off cover to
access the screw holes.
To mount the reader:
1.
Determine an appropriate mounting position for the reader.
2.
Screw off the back of the unit and place it at the desired
mounting position.
3.
Using the template as a guide, drill two holes (hole size is
indicated on mounting template) for mounting the reader to the
surface (Figure 1).
Figure 1: Mounting Template
4.
Drill a 10-mm (
7
/
16
”) hole for the cable.
5.
Route the interface cable from the reader to the controller.
The proximity reader is also mountable using strong epoxy glue.
After application, firmly hold the reader in place until the glue
dries
