UDA-8705A User Manual (Iss. 02)
User Controls • 3–3
Control and Monitoring Features
This section describes the LEDs on the UDA-8705A. Refer to
Figure 3.2
for the LED locations.
Figure 3.2
UDA-8705A Card-edge Controls
Status LEDs on the UDA-8705A
Table 3.1
provides information on the LEDs located on the UDA-8705A card-edge.
Table 3.1 LEDs on the UDA-8705A
LED
Color
Display and Description
PWR
Green
When lit green, this LED indicates that the card is operating
normally and no anomalies have been detected.
Flashing Green
When flashing green, this LED indicates that the card requires a
software upgrade.
Orange
When lit orange, this LED indicates that the card is running
internal diagnostics while powering up.
Red
When lit red, this LED indicates that an error has occurred.
Re-seat the card in the frame, verify the rear module type and
connections, or call Ross Technical Support.
Off
When not lit, this LED indicates that the card is not powered.
VIDEO
a
a.
Slowly changing, or small amplitude signals, will pass through the card, but the LEDs may be unlit.
In this case, it is recommended to disable the Notify on Input Loss alarm in DashBoard. Note that the
Input Signal Present threshold is set to assume a level of 1Vp-p.
When lit, this LED indicates that a valid analog video input
signal is present on BNC 1.
AES/OTHER
a
When lit, this LED indicates a valid AES signal, or some other
analog signal, is present on the input. The signal must be greater
than 0.5Vp-p.
PWR LED
GAIN Adjustment (RV2)
AES/OTHER LED
VIDEO LED
Bootload Button (SW1)
