2–4 • Installation
UDA-8705A User Manual (Iss. 02)
Figure 2.1
Rear Module Installation in a DFR-8310 Series Frame (UDA-8705A not shown)
4.
Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in your DFR-8300 series frame.
Installing the UDA-8705A
This section outlines how to install the UDA-8705A in a DFR-8300 series frame.
Use the following procedure to install the UDA-8705A in a DFR-8300 series frame:
1.
Locate the Rear Module you installed in the procedure “
Installing a Rear Module
” on
page 2-3.
2.
Hold the UDA-8705A by the edges and carefully align the card-edges with the slots in
the frame.
3.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4.
Verify whether your label is self-adhesive by checking the back of the label for a thin
wax sheet. You must remove this wax sheet before affixing the label to the rear module
surface.
5.
Affix the supplied
Rear Module Label
to the BNC area of the Rear Module.
This completes the procedure for installing the UDA-8705A in a DFR-8300 series frame.
Notice
— Heat and power distribution requirements within a frame may dictate specific slot
placements of cards. Cards with many heat-producing components should be arranged to
avoid areas of excess heat build-up, particularly in frames using convectional cooling.
Screw Hole
Module Seating Slot
