Ross openGear TSI-100, Руководство пользователя

Страница: 22 / 30

22 • Configuration TSI-100 User Guide (v5.0)
Alarms Status
The Alarms status reports the current state of all the signals that can cause alarms. If you wish to disable an
individual alarm clear the corresponding box in the Alarms setup tab. The following fields are displayed in the
Alarms status tab:
• Card Status — This field reports error conditions as specified in the Alarms setup tab.
• Incoming ASI — This field reports the length and speed of the incoming ASI packet.
• Video Bypass — This field reports if the card is in Active or Bypass mode (based on how
SW1
is set on the
card-edge).
• Video — This field reports when a valid input signal is connected or not to the rear module.
• Rear Module — This field reports when an unsupported rear module is installed with the TSI-100.
• TSID — This field reports the four digit hex number (Transport Stream Identification).
GPIO Output Status
The following fields are displayed in the GPIO Output tab:
• Card Status — This field reports if the GPIO connection are valid (green), or if no video source or unsupported
rear module is connected.
• Incoming ASI — This field reports the length and speed of the packet.
• Bypass State — This field reports if the card is in Active or Bypass mode (based on how SW1 is set on the
card-edge)
• GPIO # — This field reports the state of the specified GPIO. The TSI-100 has two active GPIOs. GPIO 1 is
active high and GPIO 2 is active low. An active GPIO output produces a switch closure on the rear module.