Setup (Iss. 05) • 14
Setup
Power Adapter and Supply
Connect the PS-9000 power adapter to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
CMA-9011-R. The CMA-9011-R has a standard miniature power jack (center
pin positive).
If using an adapter other than the PS-9000, ensure that:
•
the polarity is correct
•
the voltage is +5V DC regulated to 5%
•
sufficient current for the CMA-9011-R is supplied
Caution
— Use of improper adapters may damage the CMA-9011-R
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
” at the front of this manual for details.
Cable Connections Overview
Connect the cables to the CMA-9011-R according to the designations indicated
on the chassis label and
. The input is internally terminated at 75ohm. It
is not necessary to terminate unused outputs.
Figure 5
CMA-9011-R Connections
DIP Switch Setup
An 8-position DIP switch allows you to configure the CMA-9011-R to fit into
almost any installation. (
) Settings are described in
POWER
SUPPLY
SDI IN
SDI OUT 2
SDI OUT 4
ANLG CVBS
OUT 2
SDI OUT 1
SDI OUT 3
ANLG CVBS
OUT 1
Содержание GearLite CMA-9011-R
