Ross DAC-8013A, Руководство пользователя, Страница: 14 / 32

2-2
•
Installation and Setup DAC-8013A User Manual (Iss. 01)
Board Installation
Use the following procedure to install the DAC-8013A in a RossGear 8000 series digital distribution
frame:
1. Refer to the User Manual of the RossGear 8000 series frame, to ensure that the
frame is properly installed according to instructions. If this card is to be installed in
any compatible frame other than a Ross Video product, refer to the frame
manufacturer’s manual for specific instructions.
Notice
Heat and power distribution requirements within a frame may
dictate specific slot placement of cards. Cards with many heat-
producing components should be arranged to avoid areas of
excess heat build-up, particularly in frames using convectional
cooling.
2. After selecting the desired frame installation slot, hold the DAC-8013A card by the
edges and carefully align the card-edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plug is properly seated.
This completes the procedure to install the DAC-8013A in a RossGear 8000 series digital distribution
frame.
BNC Labels
Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack
frame.
Cable Connections
This section provides instructions for connecting cables to the DAC-8013A when mounted in
RossGear 8000 series Digital Products Frames. The DAC-8013A includes two sets of analog
component outputs, as well as SDI and Sync/CVBS outputs. It is not necessary to terminate unused
outputs. The serial input is internally terminated in 75 ohms. Refer to Figure 2 for BNC designations.
Figure 2. BNC Designations for the RossGear DFR-8110A (2RU Frame)