User Manual: Wireless Access Point
5
/
16
4.
Operation panel
This WAP-348X has front panel and rear panel. Front panel is used for operation,
status indication, system configure and upgrade. Rear panel is used for
communication, signal output and power supply interface.
4.1.
Front panel
1)
Detection LEDs
WAP-348X has 48 LEDs for detection indication, and supports 48 detection channels.
This almost meets all application requirements. These 48 LEDs are numbered from
1 to 48. Each LED is relevant to a certain WVD, or not used. The LED number and the
relevant WVD ID are identical. The LED status represents the relevant WVD’s
detection result. This is described as the following table:
Status of LED
Description
Off
No WVD is bound to this LED, or the WVD is out of work.
Red
A vehicle is detected by WVD installed in this channel.
Green
No vehicle detected.
Green flash
WVD warning.
If there is no WVD or the WVD has not connected to the WAP-348X, the
corresponding LED will be OFF. In this situation, customers need to check whether
the WVD out of works. If the status of LED is green flash, which indicates the relevant
WVD has fault, it needs repair or replacement. If WVD connects to WAP-348X and
works normally, the LED will be green, and it turns to red when a vehicle detected.
Please note that if a WVD is just installed, the corresponding LED on the WAP-348X
will keep red, even if there is no vehicle detected. This is a normal calibration process
for a newly installed WVD, and will be finished in a few minutes.
