ROSIERES TRIPLE 10 G, Инструкция по использованию и установке, Страница: 30 / 36

Memorization of the last programme used
The last programme used can be memorized by following the
below:
IMPORTANT
The dishwasher must ALWAYS be off before start of this
procedure.
1. Hold down the "PROGRAMME SELECTION" button and at
the same time switch on the dishwasher by pressing the "ON/OFF"
^]SSVQM›TM^ZPXdMT]WP^UXMRPfQTUM²PUUMRV]QWœg
2. Keep the "PROGRAMME SELECTION" button pressed for at
UXTRSMƒ‹MRX_VQWRM›W]ZPQfMS`PRMSPaXiMƒMT]WP^UXMRPfQTURM²PUUMRV]QWœg
3. Release the button when the THIRD MT]WP^UXMRPfQTUMRV]QWRM›TUUM
S`XMPQWP_TSVZMUPf`SRM²PUUMdUTR`œg
gMvZXRRMS`XMRTaXM^]SSVQMTfTPQwMS`XMdUTR`PQfMPQWP_TSVZMUPf`SM
›aXaVZPnTSPVQMVddœM²PUUMRSV[MdUTR`PQfMTQWMZXaTPQMVQM›aXaVZPnTSPVQM
VQœg
5. Turn off the dishwasher by pressing the "ON/OFF" button to
confirm the new setting.
To disable the memorization, follow the same procedure.
WARNING!
If any problem occurs, turn the dishwasher off by
pressing the "ON/OFF" button and start the procedure
again from the beginning.
Fault Signals
If malfunctions or faults occur when a program is running, the LED
S`TSM_VZZXR[VQWRMSVMS`XMRXUX_SXWM_q_UXM›„MN† mMdVZMk—N M”pm†M
[ZVfZTaaXœM²PUUM^UPQrMZT[PWUqMTQWMTQMT]WP^UXMRPfQTUM²PUUM^XMT_SPYTSXWg
In this case, turn the dishwasher ofdM^qM[ZXRRPQfMS`XM—QMzM—ff button.
After checking to make sure the water inlet hose tap is open, that
the drain hose is not bent and that the siphon or filters are not
clogged, re-start the selected program. If the anomaly persists,
contact Customer Service.
Important !
To ensure the correct operation of the anti-overflow safety
device, it is recommended not to move or to tilt the dishwasher
during operation.
If it is necessary to move or to tilt the dishwaher, first make
sure the washing cycle is finished and that no water is left in
the tank.
If there is any break in the power supply while the dishwasher
is operating, a special memory stores the selected programme
and, when the power isrestored, it continues where it left off.
Attention - The dishwasher is equipped with an anti-overflow
safety device which in the event of anomaly intervenes by
evacuating water in excess.
The filtering system is composed
a vua~
- a central filter cup which traps the
largest food particles.
- a flat filter which continuously filters
the washing water.
- the micro filter, situated under the
flat filter, which traps the smallest food particles ensuring a
perfect rinse.
For best results, the filter unit should be checked and cleaned
after each wash.
To remove the filter unit, simply grip the handle and lift the whole
unit out.
The central cup is just resting on top for easy cleaning.
The dishwasher is fitted with a self cleaning micro filter, which only
requires checking about once every 15 days.
However, it is advisable to check after every wash, that the central
cup and the flat filter are not clogged.
NB : After cleaning the filters, make sure that they are correctly
reassembled, one inside the other, and that the flat filter is properly
positioned at the bottom of the dishwasher.
A poor seating of the filter unit could have an adverse effect on
the efficiency of the appliance.
”§ªvx}„}a~aŸt‚txa ˆta}yta®zˆy±„ˆytxa±z}yv }auz{}tr.
PRELIMINARY OPERATIONS AND
CLEANING THE FILTER UNIT
{i/Ž
USE THE DISHWASHER