8
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep expansion pipe short and straight.
• Do not reduce the size or restrict expansion pipe.
• When using expansion pipe always install the pipe pulled taut to minimize pressure loss.
• Failure to observe these basic instructions will reduce the performance and increase
noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent person.
•Do not connect the ducting system of the hood to any existing ventilation system which is
being used for any other appliance ,such as warmer tube, gas tube , hot wind tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must direct
the pipe horizontally, or, alternatively, the pipe should go up from the initial point and
should be led to an outer wall.
•After the installation ,make sure that the cooker hood is level to avoid grease collection at
on end.
•Ensure the expansion pipe selected for installation complies with relevant standards and
is fire retardant.
WARNING:
For safety reason, please use only the same
size of fixing or mounting screw which are
recommended in this instruction manual.
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.
Start Using Your Cooker Hood
LED touch control
1.Press the “Power” button, the button control the “on” & “off ” of the hood.
2.Press the “Speed” button time after time, the motor runs as low / mid / high / low / mid…,
the speed runs circularly; and the LED display will indicate as 1-2-3-1-2… circularly.
Timer Lamp Speed Power
