9
3.Press “Lamp” button, the light is on, press this button again, the light is off.Please note
the Lamp is not under control of the on/off button.
4.When the hood is working, if press the “Timer” button, the hood will go into the status of
acquiescent working (acquiescent time is 9mins), and then, LED display will be shown
9.8.7.6 ...decreasing by 1,when time is up, the hood will be off automatically and the lamp
will extinguish. If pressing “Timer” button, the hood will go in or go out “Timer” function.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not
work, motor does
not work
House fuses blown
Reset/Replace fuses.
Power cord loose or
disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet
are not tightly sealed
Take down the one way valve
and seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working
Broken/Faulty globes
Replace globes as per this
instruction.
Insufficient suction
The distance between the
cooker hood and the gas top is
too far
Refit the cooker hood to the
correct distance.
The Cooker hood
inclines
The fixing screw not tight
enough
Tighten the hanging screw and
make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and federal
laws.Please contact the service centre if in any doubt before undertaking any of the
above.Always disconnect the unit from the power source when opening the unit.
CUSTOMER ASSISTANCE SERVICE
If you cannot identify the cause of he operating anomaly;switch off the appliance (do not
subject it to rought treatment.) and contact the Assistance Service.
PRODUCT SERIAL NUMBER.Where can I find it?
It is important that you to inform the Assistance Service of your product code and its serial
number(a 16 character code which begins with the number 3);this can be found on the
guarantee certificate or on the data plate located on the appliance.
It will help to avoid wasted journerys to technicaians,thereby (and most significantly)
saving the corresponding callout charges.
