Rosen ClearVue CV6821, Руководство пользователя

Страница: 5 / 14

ClearVue 6821 DVD System Owner’s Manual
Page 4
About the ClearVue 6821 DVD System
Welcome to the ClearVue 6821 DVD System Owner’s Manual .
The ClearVue 6821 DVD system includes the following
components:
•
Overhead Monitor
•
DVD Player with TV Tuner
•
Wireless IR Headphones (2 pair)
•
Wireless IR Transmitter Dome
•
Remote Control
•
FM Modulator (enables the DVD sound to be
heard over your vehicle’s speakers).
•
Vehicle Trim Ring
• Other parts and cables which are installed out of sight
in your vehicle.
Note: The system is intended to be used with your ignition
key switch in the Run or Acc position. Extended use
of the system without the engine running should be
avoided, as it could drain the battery.
About the ClearVue 6821 DVD System
Page 23
Rosen Products
Frequently Asked Questions
Why don’t I hear ClearVue sound over my radio?
Try both 89.1 FM and 88.7 FM on your radio dial, and make sure
that the FM Modulator is on by pressing and releasing the
“SPEAKER ON/OFF” button on the remote until “FM ON” is
displayed on the screen.
Why doesn’t the TV button on the remote turn on the
TV Tuner?
Some buttons on your ClearVue remote are for other Rosen
systems and products. Use the
MODE button to turn the TV
Tuner on with your system.
How do I change channels on the TV Tuner?
Press the up and down arrow buttons on the remote.
Why did the headphones stop working?
Check the power switch and the volume control. Check the
MUTE button on the remote. Then try adding new batteries.
Why did the remote stop working?
Direct remote towards the black oval above the monitor when
pressing buttons. Then try adding new batteries.
Why do I have poor ClearVue sound quality sometimes
over the speakers?
You may be in an area that has a strong radio signal at the same
FM frequency as the FM Modulator. See your Rosen dealer to
have the ClearVue FM frequency reset.
Why do I have a poor Video on my screen?
Your DVD players setup may be set to PAL. Check to verify that
your “TV Type” in the setup menu is set to NTSC.
Frequently Asked Questions