ENGINEERING STANDARDS
Rosedale Products, Inc.
IOM
Issue Date: 31JUL02
3730 West Liberty Road
7_3_5 Model LCO 6.wpd
Revision: A
Ann Arbor, MI 48103
n:\iom\
Revision Date: 30May2003
Specification No.
7.3.5
PAGE: 2 of 6
INSTALLATION, OPERATION, & MAINTENANCE MANUAL
Rosedale Engineering Standards are the property of Rosedale Products, Inc. A Rosedale standard or copy thereof shall not be distributed (except with express approval of Rosedale
Products, Inc.) to any individual or firm beyond the intended recipient firm or individual. Firms of individuals acting contrary to the above may be subject to suit, ineligibility for continued or
future employment, or removal from Rosedale’s "Approved Manufacturers and Specialty Contractors List".
I.
INSTALLATION
Please remove all shipping and crating materials carefully. Be sure to remove the plugs from the inlet and
outlet openings. Dispose of all crating materials safely.
The Model
LCO-6
Filter unit is capable of having several different piping variations based upon the outlet
style of your unit. The inlet service line should be connected to the inlet NPT coupling located near the top of
the unit (above basket level).
The outlet service line should be connected to the outlet coupling, located near the middle or bottom of the unit
depending upon the style of your unit (below basket level).
There are two 1/4" NPT ports on the shell of your Model
LCO-6
Filter. These ports can remain plugged or
used for pressure gauges, vents, or special fitting as your application requires.
Some installations require electrical grounding of all equipment, be sure to provide adequate grounding where
necessary.
After completing installation be sure to double check connections for integrity. Your Model
LCO-6
Filter unit
has been factory pressure tested leak free, therefore, any seepage problems usually occur from improper
installation connections.
You are now ready to install the filter basket and bag (if applicable). Remove cover by loosening the T-bolt
clamp sufficiently to allow removal of the clamp assembly, lift cover to remove.
The next step is to install the strainer or filter bag basket. When a strainer basket is utilized it is recommended
that an o-ring be installed under the rim of the strainer basket to prevent by-pass of unfiltered fluid (specify
basket seal on order).
If your installation requires a filter bag, place bag into the bag basket and insert bag and basket into the housing
making sure the filter bag ring is firmly seated on the I.D. of the housing. This configuration does not require a
basket seal, the bag ring serves as the seal.
Before replacing cover assembly, inspect cover seal gasket (replacing as necessary). Replace cover and
securely tighten T-bolt clamp closure to ensure a leak proof seal between cover and housing body.
Your Rosedale Model
LCO-6
Filter is now ready for operation!
