Rose electronics UltraVista LC, Инструкция по установке и эксплуатации

Страница: 15 / 25

UltraVista LC Installation and Operations Manual 11
OSD Menu Structure
To reset the UltraVista LC to factory defaults, Press the “UP”,
“Down”, and “Enter” buttons simultaneously until the “Reset
to Mfg Default” message appears on the monitor connected
to DVI output connector #1.
Table 1 below shows the OSD menu structure.
Menu
Options Description
MASK
Toggles the mask function ON /
OFF
X Sets the horizontal mask value*
Mask Control
Y Sets the vertical mask value*
LINK Toggles the link between the master
video unit’s mask value and the
slave’s value Link Control
(2x2 and 3x3 only)
Scan Toggles the scan function ON / OFF
for detecting the attached slave
units
DVI Displays DVI output settings with
link on
Displays individual settings with
link off
X Sets the horizontal mask value
Slave Mask Setting
(2x2 and 3x3 only)
Y Sets the vertical mask value
OUT Sets the output resolution Settings
MODE Sets the output mode
Warning Change
Setting Warning that the output resolution
OUT Displays the Units output resolution Information
IN Displays the Units input resolution
DS
H Slave’s horizontal output resolution
Slave Output Resolution
(2x2 and 3x3 only)
V Slave’s vertical output resolution
SYNC Sync and Power
Power Turns the power on and off
FPGA FPGA chip version number
CPLD CPLD chip version number
Version Information
FW Firmware version number
Name Displays the model name Model Information
SN Displays the model serial number
* See page 8 for “X” and “Y” value calculations
Table 1. OSD Menu Structure