UltraVista LC Installation and Operations Manual
9
Mounting the UltraVista LC unit
The UltraView LC unit can be placed on a desk or mounted on a horizontal
or vertical surface using the included mounting brackets. To mount the unit
using the mounting brackets, remove the four rubber feet and secure the
mounting brackets to the unit using the same holes and screws as shown
below.
The installation location must be:
Centrally located so all cables can connect to the unit*
Out of direct sunlight
No items placed on top of the unit
On a firm surface or secured with the mounting brackets
Away from any moisture or liquids
Observe proper cable strain relief techniques
* If extended distances are needed from the UltraVista LC to the video
source or to the display monitors, Rose Electronics’ video extender line
can extend this distance up to 400 feet using CATx cabling or 6 miles
over fiber cabling.
Connecting the cable
Attach the provided DVI video cable from the UltraVista LC DVI input
connector to the DVI video source. If the video source is VGA, a VGA to
DVI converter must be used.
Each monitor connects directly to the corresponding DVI connector on the
UltraVista LC’s rear panel. Refer to Figure 1, 2, and 3 for monitor
numbering.
Connect a DB-9MF serial cable to the DB9F serial connector on the
UltraVista LC rear panel and to the DB-9M serial connector on a computer
that will be used to send serial commands to the unit. See Figure 5 for an
example of the cable installation and the RS232 section for instructions on
sending serial commands to the unit.
