Rose Band ShowLED Classic, Руководство пользователя

Страница: 5 / 24

5
SAFETY INSTRUCTIONS
WARNING
To avoid electric shock the power cord protective grounding must be connected to
ground.
Make sure you understand the function of each connection before you connect it. See
that all connections are made correctly before turning on the controller.
Always disconnect the device from the mains supply when connecting the signal
leads, the power cord should be connected last.
Do not apply voltage higher than 260 Vac to the device. (See also technical data)
In case of an emergency, you can disconnect power from the device by pulling out the
power cord. Keep the power cord easily accessible at all times.
If your application set-up does not allow easy access to the power cord, install a
mechanical circuit breaker in the supply-line, going to the device.
The device has 2 fuses placed inside; replace them only with the correct type. See next
page how to replace them.
If the controller hangs on a starcloth and is not supported by a floor or a table, you
must secure it with a mechanical safety. The connecting cables are NOT mechanical
safeties! If you are not familiar with mechanical safeties, feel free to contact us, we can
provide you with advice.
Take care with the environmental limits. Do not exceed them. (See technical data)
Keep a minimum distance of 1 meter between you (or the audience) and the LEDs.
Do not stare into the LEDs, especially when narrow angle LEDs are used.
This device is designed and tested for driving LEDs; do not use it for other purposes.
Do not expose the controller to water (rain) or direct sunlight.
Do not subject to excessive shock by dropping the unit.
!