RevoPRO Operations Manual
p. 7
To load a gobo into the gobo wheels
1. Place the rotator on a stable flat surface. Unscrew the Threaded Collar
from each gobo wheel (counter-clockwise to unscrew, clockwise to
tighten).
There are two flat sections on the collar to give your fingers a place to
grip. If the collar has been over tightened and is stuck, another small
machined spot on the outer ring allows you to gain purchase when
spinning the collar opposite to the entire gobo wheel.
2. Once the Threaded Collars are removed, insert a B size gobo so that it
lays flat against the gobo wheel.
TIP
:
When installing a metal gobo, an optional Gobo Spacer Ring
(Part no. 205 83007 0000) is available to increase the separation be-
tween the gobos to achieve a wider range of focus effects. This spacer
can also be useful if two metal gobos with fine thin details are being
used. In the event that the heat from the luminaire causes the gobos
to warp towards one another, use of the spacer ring will prevent the
gobos from getting tangled together.
3. Screw on the Threaded Collar until just in contact with the gobo. Do
not over tighten.
The Threaded Collar has Teflon™ threads to ease rotation and avoid
binding however there is still a small risk of cross threading. Do not
forcibly screw on the Threaded Collar . If you encounter undue resis-
tance, back off and start again. Lay the Threaded Collar flat onto the
ring and slowly and evenly rotate until the threads align and engage
properly.
