Rosco Miro Cube 4CA, Руководство пользователя

Страница: 23 / 36

Serial Mode
23
In Serial mode, the unit is controlled by the serial data it receives on the XLR
connector located on the rear panel or via CubeConnect®. If your unit does not
have Serial Mode you will need to enable it by entering FACTORY SETUP using
the MENU button. For the password enter “3270” . Using the MENU button to
toggle through the options select SET CONFIG OPTIONS and click OK . Next use
the MENU button to toggle through the options select SERIAL MODE ON and
click OK . Finally click OK to exit.
The serial address required to control the fixture is dependent on the factory setting in
use. See p.16 for Braq DMX channels.
Serial Address
To change the Serial address, press
MENU
until
“CHANGE SER ADDRESS?”
appears on the LCD, and press
OK
. Select the desired Serial address using the
or keys, and press
OK
.