52-51413 REV B
6
3 CAMERA OPERATION
3.1 GENERAL
Operation of the RS-485 CEX-HD Camera is straightforward, but there are some
differences, which may not be familiar to personnel accustomed to operating closed-circuit
TV systems. The RS-485 CEX-HD is designed to be used with only the ROS IC-LINK
controller.
3.2 INSTALLATION
STOP
– WARNING! READ BEFORE DEPLOYING
The connector pins on this cable assembly are keyed to ensure proper alignment when
mated.
Forcing the connectors to mate with the pins misaligned will cause equipment damage not
covered under warranty.
For
LPMBH-6-MP (configuration -01) the logos will be aligned as shown in Figure 3 when
the pins are aligned correctly.
Figure 3: Correct alignment of LPMBH-6-MP cable connector (-01 configuration)
For ease of mounting, the RS-485 CEX-HD camera has a mounting saddle, integral to its
housing, with two 1/4-20 UNC tapped holes on 2.00-inch mounting centers. The camera
must be mounted in a position that will protect against impacts with obstacles passing close
to the camera. The camera housing should be electrically isolated from the mount with a
thin piece of rubber, electrical tape, or other non-conductive material in order to reduce
effects of galvanic corrosion from metal-to-metal contact in water.
