Galaxy HDX4 RAID Quick Install Guide
-
4 -
Contact Rorke Tech Support 800 328 8147
3 Adjust Rail Length
: Verify the rails are adjusted to the correct length by loosening the
4 screws and sliding the rear sections to meet the rear rack post. Tighten the screws
when done.
4 Attach Rail to Posts
: Secure the rail to the front and rear rack posts each using two
position screws. (See figure below) Do not insert the screws into the cage nuts as cage
nuts will be used to secure the enclosure later.
5 Attach Bezel Filler Plate
: Attach the bezel filler plates (#04) behind the enclosure
ears using the three #6-32 x 12mm flat head screws (#09) on each side.
