4.
Now that the 2 x Support Blocks have been securely fitted to side
A
, lift in the Blind frame and rest it on the Support
Blocks. Then lift up the frame for side
B
, once in position get assistance to screw in the remaining 2 x Supports Blocks
into the OSB board as per the diagram below.
Step 2
1.
Using the screws provided, locate the predrilled holes on all 4 x sides of the frame and screw the frame securely
in place
(try and avoid bending the frame, packers may also be required to keep it square)
.
Make sure the frame is
completely level with the top of the upstand
. Remove
ALL
the Support Blocks holding up the frame on side
A & B
once it is secure.
MEASUREMENT CHECK: Now the frame has been fully fitted ensure the measurements across the frame are equal (measure
both ends
and the centre of the frame, all measurements should be equal - a maximum of 2mm tolerance is allowed).
2.
Plasterboard up to the frame and skim flush.
Only fit the Blind after this has been done to avoid damage
.
3.
Clean all the frame to remove all the plaster dust and any lumps of plaster and ensure the surface of the frame
is free from dirt, dust and debris.
Step 3
1.
Unwrap the Blind and lay it out on a clean surface under the
Lantern. Check that the motor side is positioned under side
A
of the
lantern and the Blind is the correct way up (indicated by the stickers).
Fitting Guide (V.1) |
2 of 6
