Ensure all personal protective equipment is inspected and in place prior to ascending with
the Ronin Lift.
Ensure you are using a secondary rope grab system as a
backup, with a second independent rope.
Attach your harness to the lower attachment point on the Ronin, with a carabiner. Roll down
the thumbwheel slowly and remove the slack from the climbing line. Now sit down into your
harness and hang from the Ronin. Ensure that your brake is holding you in place and is not slipping.
Rotate the thumbwheel down and ascend approx. 10ft, then stop. Make sure the system is
not slipping on the rope. The Ronin is a no slip system, so if the system starts to slip on the rope,
then stop. Turn the Red Tensioner Knob 1-2 additional turns to the Right, until the system no
longer slips and continue your ascent.
Ronin Lift New User Guide
PN: 2805-11
Ascending
Descending
To descend… Pull down on the red brake handle with your left hand and simultaneously TAP
the thumbwheel trigger with your right hand to dislodge the brake wedge. (Note: If you do not
descend, this is due to over tensioning the system for more weight than you are lifting. Slowly turn
the Red Tensioner Knob to the Left, while holding the brake open, until you start to descend.)
Keeping the brake fully open, now tend the rope with your right hand. Pull down on the rope
to slow and stop. Once stopped, release the brake handle to hold in place. (Note: You can always
just release the brake at any time to stop but this will add additional wear to your rope overtime.)
5
REV. Q: DATE: DEC 10 2020
