Ronde & Schwarz CLIPSTER, Руководство по оборудованию

Страница: 35 / 98

Overview

Overview of the Rear
35 CLIPSTER | Hardware Guide | Hardware Generation V+
Rohde & Schwarz DVS GmbH
Main Connector Panel
The main connector panel provides the standard in- and outputs
of CLIPSTER to give you the full functionality of the system. It
holds, for example, the connectors for remote control and the
digital video in- and outputs (serial digital interface).
RGB 4:4:4 G, ½ R,
½ B ½ R, ½ B G, ½ R,
½ B
½ R, ½ B Y, C
b
, C
r
(SD)
Y, C
b
, C
r
(SD)
RGBA 4:4:4:4 G, ½ R,
½ B
½ R, ½ B,
A (key) G, ½ R,
½ B ½ R,
½ B,
A (key) Y, C
b
, C
r
(SD)
Y, C
b
, C
r
(SD)
1.Ports 5/6 and 7/8 normally mirror the ports A/B and C/4. In special rasters all ports provide different
image content (quad HD-SDI, also in 3 Gbit/s).
2.Software switchable to 3 Gbit/s (level A and B). Port C provides then a mirror (3 Gbit/s) of port A.
3.During stereoscopic outputs used for the second video stream when in single-link (YUV) or in 3-Gbit/s
mode (e.g. RGB).
4.Normally a mirror of connector pair A/B. During stereoscopic outputs used for the second video
stream when in dual link mode.
5.Always a mirror of SD-SDI Out 1.
SDI signal distribution during output (Forts.)
Video Mode
SD/HD-SDI
1
SD-SDI
Out 1/A
2
Out 2/B
3
Out 3/C
4
Out 4
4
Out 1
Out 2
5
Pin-outs of most connectors can be found in section
“Signal In- and Outputs” on page 82.
For the availability of connectors not present at the sys-
tem’s rear (blind panels) please contact R&S DVS GmbH.