Page 5
Operation instructions
1. Prepare a full cylinder gas according to the heating requirements and make
sure the gas pressure gets 1.5 bar. Connect one end (with pressure adjusting
valve) of the gas hose to gas cylinder, tighten the connector nut to make sure
no gas leakage happens.
（
Figure 1
）
2. Put the heater on a stable working underground, take away the protection
guard from the machine
，
connect the other end of gas hose with machine and
tighten the locking connector nut to ensure the soundness of the gas
inlet.
（
Figure 2
）
3. Open the gas tap
，
press down the button of the pressure regulator to let the
soft hose be filled with gas
，
check the soundness of the connection
again.
（
Figure 3
）
4. Set the regulator to the maximum setting.
（
Figure 4
）
5. Make sure the machine is proper connected with the gas cylinder and the
power switch is at the “OFF
（
O
）
”position
，
plug the power plug in the socket
outlet
，
shut on the power switch
（
put the power switch at the
“ON
（
1
）
”position.
（
Figure 5
）
6. When the turning of the fan blades becomes stable
，
use the right hand to
push the aluminum handspike of the flameout protector and keep for 10
seconds, then use the left hand to press the igniter button for ignition
，
after
the gas ignites keep on pressing the handspike for another 10 seconds then
release the right hand and the gas will burn continuously.
（
Figure 6
）
7. Turn the adjustment knob to regulate the flame length and make it comply with
the corresponding heat input.
8.
Repeat the above 3-7 steps when the machine runs out of gas and a new full
cylinder is to be replaced.
