Romus 93444, Инструкция пользователя

Страница: 15 / 17

15
HOT AIR CANNON « K-37 » - DIesel
Ref 93444
47
Adjusting pressure on compressor pump
A pressure meter must first be installed in order to adjust the compressor pump
pressure. Order an original from your dealer.
 Remover upper cover and fan grille
 Remove the manometer plug on top of the filter lid
 Install the manometer
 Start the heater
 Let the motor run at full power
 Adjust the pressure with a screwdriver (flat head)
 Turn the valve in a clockwise direction in order to add pressure; turn anti-
clockwise to reduce pressure
 Set the right pressure for your heater model:
 Model  Pump pressure
 OK22T  4.0 psi
 OK37T  5.0 psi
 OK63T  7.0 psi
 Turn the heater off
 Remove the manometer and replace the plug
 Replace the fan grille and upper cover in their usual positions.
Long-term storage
 Undo the tank cap on the tank
 Use a siphon or similar pump that is suitable for fuel to suck all of the fuel out of
the tank
 Pour a little clean diesel or paraffin into the tank and rinse out
 Empty the tank completely
 Never mix water through the fuel as this will rust the tank!
 Never leave fuel sitting in the tank if the heater is to be out of use for a while; old
fuel can damage the heater!
 Store the heater in a safe, dry and well-ventilated location, outside the reach of
children.
 Make sure that the storage area is not dusty and does not contain any corrosive
vapours
 Store the heater in the original packing
 Store the instruction booklet in an accessible place
5.0 psi