Mode
d’emploi
Mixers « ROMIX »
194010
–
194014 - 194019
Starting Operation and Use
Manual user
Electronic Morot control
Improper use may damage the instrument.
Observe therefore these instructions:
-
Use a tool up to the specified diameter.
-
Load the instrument in such a way that the speed
would not drop considerably or that it would
stop.
Check if the data on the rating plate correspond with
the actual mains voltgae. Instrument scheduled for 230
V can be plugged to 220 V / 240 V mains.
Fixing a whisk
Screw tools with thread M 14 x 2 as far as possible in
the tool mount and tighten properly with an open-end
wrench (22 mm) from among the accessories.
Switching on and off
By pressing the switch buttonnthe apparatus is brought
into operation and it stops when this is relieved.
By subsequent pressing and relieving of the switch
button the permanent run in interrupted.
Permanent run
By pressing the switch button to the stop and
simulatneous presing the arrestinf pin permanent run is
achieved.
By subsequent pressing and relieving of the siwtch
button the permanent run is interrupted.
Unloading the tool (whisk)
Fit a flat-end wrench (22 mm) on the hexagon end of
the tool (whisk) and unscrew the tool from the spindle
by tugning it to the left.
Starting current limiting
The electronically controlled smooth start takes care that
the machine starts without jerk. In this manner, the
splashing of thin liquid materials is prevent at the same
time when switching on the machine.
As a result of the machine’s reduced strating current, a 16
A use is sufficient.
No-load speed reduction
The electronic control reduces the no-load speed of the
machine which results in reduced noise and wear of
motor and gear.
Speed pre-selection
With the speed control (10), the speed can be
coninuously pre-selected:
The necessary speed is dependent on the type of material
to be mixed. It is recommanded that be confirmed wiith a
practical trial.
Speed selection
Two rpm ranges can be preselected with the speed
selector switch (5)
Speed 1 : 150
–
300 rpm
Speed 2 : 300 - 650 rpm
The necessary speed depends on the type of the material
mixed and it is recommended to verify it by a practical
test.
Constant electronics
The constant electronics keeps the speed between no-
load and load nearly constant and ensures uniform mixing
of the materials.
Electronic overload protection
In case that the machine is extremely overloaded and
electronic overload protection protecs the motor from
damage. In this case the motor stops and restarts only
after the feeing pressure is reduced, res. After relisf.
13-15 rue Taillefer 91160 Champlan
