31
d) Programme-phase “4“ – Keep-warm function
NOTE:
If the keep-warm function is not requested, the programme sequence can be interrupted at any
time by pressing the button “Start/Stop” and holding it for at least 2 seconds or disconnecting the mains
plug from the socket.
• The appliance is in the keep-warm function.
• The display shows the time of keeping warm in an ascending order and display “4” is flashing.
• When the keep-warm time is expired, a longer signal tone sounds.
Lifting the jug during keeping warm
• If the jug is lifted during the keep-warm function, the keep-warm time stops in the background.
IMPORTANT: There is no automatic continuation of the keep-warm function after placing the
jug on the base unit.
• After lifting the jug, the display shows „10:00“ minutes and displays “1 to 4” are flashing. There are
10 minutes left to replace the jug and to continue the keep-warm programme.
• If this does not happen, the programme is quit and the appliance switches to selection mode.
• Time counts backwards in 1-sec. steps.
• After replacing the jug, “Time”, display of “phase 4” and the button
“Start/Stop” is blinking.
• The keep-warm function can be continued by pressing the button “Start/Stop”
again.
Pressing the button is confirmed by a signal tone and the button is lit
permanently.
• At the end of the keep-warm time, there is a triple signal tone and the appliance switches to selection mode.
