9
5 Put on the Bearing(part #3), then put on Bearing Cover (part #4)
6 Tighten the bearing Gently with Main
Column Nut(part #5)
7 Screw the Magnetic pads for azimuth module (part #7 & 9). After finishing, stick the
thick rubber pads (part #11). Do not remove the upper tape at this moment.
8 Install the azimuth encode magnet (part #6). Insert several washers (part #8) to
make the magnet inside the zone where the azimuth encoder could sense.
Tip: The quantity of the encoder washers should be adjusted as following guidance.
