11
10 Screw the Magnetic pads for altitude
module
(part #7 & 9). After finishing, stick the
thin rubber pads (part #10).
11 Install the altitude encode magnet on
the altitude side cover (part #14). Insert
several washers (part #8) to make the
magnet inside the zone where the altitude
encoder could sense.
Tip: The quantity of the encoder washers
should be adjusted as following guidance.
Make sure the head of Encoder Magnet
little passing through the Encoder
Alignment Plate as well
. If not, put more
or take away the magnet washers to adjust
its height.
12 After confirmation, connect the data
wire (part #12) to complete the altitude
module installation.
