1. If fitting to a tray the glass slot in the wall profile must be in line with the glass groove, using a pencil mark the locations for
the drill holes on the wall surface using the holes in the wall profile as a guide.
•
The wall profile must be completely vertical (the bubble should be in the centre of the two lines on the spirit level).
•
The screws down the side of the wall profile must face in towards the showering area.
2. Drill the holes using 6mm masonry drill bit (not supplied). Push the wall plugs (supplied) into the drilled holes.
3. Apply a bead of silicon the width of the wall profile at the bottom where it meets the tiled wall.
•
Important:
failure to carry out this procedure can result in serious water damage and is not covered under the
terms of the guarantee.
4. Screw-fix the wall profile to the wall using the 40mm screws (supplied).
•
Important:
no sealant should be present between the wall profile and the tiled wall vertically prior to screw-
fixing.
5. Using an allen key loosen the screws down the side of the wall profile by 3 turns.
6. Position the flexible seal onto the end of the side panel. Offer the side panel fully into the wall profile then tighten all the
allen screws down the side of the wall profile using the supplied allen key.
•
The glass panel must be completely vertical prior to tightening the screws (the bubble must be in the centre of the
two lines on the spirit level).
7. Once you are completely satisfied, clip on the wall profile cover trims. Screw-fix the top caps to the wall profile assemblies.
•
The wall profile cover trims are designed to be a tight fit.
8. Important: Now follow Step 5, lines 3-4 to seal the side panel correctly.
•
Important:
failure to follow this procedure correctly can result in serious water damage and is not covered under
the terms of the guarantee.
Step 6 - Fitting the Side Panel
➄
&
➅
Side
Panel
➂
➃
➆
➁
➀
Flexible Seal
SNCW-SNWCG:CQB
14/5/10 11:35 Page 7
