IMPORTANT PRE-INSTALLATION CHECKS
1. Check the tray is level, on all sides (the bubble should be in the centre of the two lines on the spirit level).
2. Stand in the tray and check for no adverse movement.
3. The walls should be tiled and grouted up to the tray.
4. The tiles and the tray should be sealed, using a good quality bathroom sealant.
•
Spray the seal and joints with the shower head and check for leaks when the silicon has cured.
•
Check the plumbing for leaks.
•
Do not plasterboard over the tray.
•
Do not grout the tiles when the enclosure has been fitted as the grout may discolour the aluminium profiles.
•
Make sure the tray is installed as per manufacturer’s instructions.
•
When all of the above has been completed please proceed to Step 2.
Important:
If you are fitting in conjunction with the integrated water delivery, you must refer to the valve fitting instructions
before installing your enclosure or tray.
Under floor preparation will be required to accommodate the valve prior to the installation of the enclosure, tray or final
construction of the wet-room.
Step 1 - Checking & Sealing the tray
Please make sure the purchaser/end user completes and returns the Guarantee card which is enclosed with
this product or registers on line at
www.roman-showers.com/register_guarantee.htm
. Failure to validate the
Roman Truelife Guarantee will mean only the 1 Year Statutory Guarantee will apply.
Truelife Consumer
Guarantee
BEFORE COMMENCING INSTALLATION
PLEASE ENSURE THAT THE SITE AND
TRAY REQUIREMENTS HAVE BEEN
COMPLETED.
The installer becomes liable for any call
out and/or rectification costs if the problem
found is a result of an attempted
installation on an unacceptable site.
➂
➃
➁
➀
SNCW-SNWCG:CQB
14/5/10 11:35 Page 2
