1. Check the tray is level on all sides (the bubble on the spirit level must be in the centre of the 2 lines).
2. Stand in the tray and check that there is no adverse movement (correct if necessary).
3. The walls should be tiled and grouted up to the tray.
4. The tiles and the tray should be sealed using a good quality bathroom sealant.
• Spray the seal and joints with the shower head and check for leaks when the silicon has cured.
• Check the plumbing for leaks.
• DO NOT plasterboard over the tray.
• DO NOT grout the tiles when the enclosure has been fitted, the grout may discolour the aluminium
profiles.
• Make sure the tray is installed as per the manufacturer’s instructions.
• When all of the above has been completed please proceed to the Step 2.
Step 1 - Pre-Installation Checks and Aperture Sizes
Panel Sizes
Minimum
Maximum
900 Panel
865
880
1200 Panel
1165
1180
IMPORTANT: The above are finished tiled sizes
